| U.W.T. INC. Instructions |
| *TO REMOVE WEIGHTS FROM STANDARD WHEELS & TIRES |
 |
| STEP 1 - SELECT HOOK (Photo #1& 2)(#5 SERIES REMOVES THE MAJORITY OF ALL WEIGHTS)(#7 SERIES REMOVES ASIAN O.E. AND AFTER MARKET FN WEIGHTS, weights with the tiny hole, AND A FEW OTHER STUBBORN WEIGHTS THE #5 MAY NOT REMOVE) |
Photo #1
Photo #2 |
|
| STEP 2 - INSERT END OF HOOK FIRMLY INTO WHEEL WEIGHT CLIP HOLE, HOLDING TOOL AS SHOWN IN PHOTO BY HANDLE OR HAMMER HEAD "TO AVOID INJURY DO NOT PUT FINGER OR HANDS NEAR HOOK TIP" (Photo #3 & 4) IF HOOK DOES NOT IMMEDIATELY ENGAGE STOP AND USE OPPOSITE HOOK!! (If hook is not firmly engaged in hole, slippage and the possibility of rim scratching may occur) |
Photo #3
Photo #4 |
|
| STEP 3 - WHILE HOOK IS FIRMLY IN WEIGHT HOLE APPLY DOWNWARD PRESSURE TO HANDLE TOWARD CENTER OF WHEEL AND REMOVE WEIGHT.(Photo #5) |
Photo #5 |
|
| *TO REMOVE "CLIP ONLY" WEIGHTS (WEIGHTS WITH NO BODY FOR LEVERAGE) |
FOLLOW STEPS 1 & 2 (Photo# 6) NEXT, PLACE AND HOLD HEEL PLATE ACCESSORY (Provided with tool) ON TOP OF THE CLIP, FLUSH AGAINST THE WHEEL RIM
PROCEED TO STEP 3, USING THE HEEL PLATE FOR LEVERAGE. (Photo #7) |
Photo #6
Photo #7 |
|
| *TO REMOVE WEIGHTS WHERE TIRE BEAD IS EQUIPPED WITH "CURB PROTECTOR RUBBER |
| FOLLOW STEP 1 NEXT, INSERT HOOK PARALLEL BETWEEN THE WEIGHT CLIP AND TIRE BEAD (Photo #8). TURN HANDLE 1/4 TURN, ROTATING THE HOOK END FIRMLY INTO THE WEIGHT CLIP HOLE. (Photo #9) IF HOOK DOES NOT IMMEDIATELY ENGAGE STOP AND USE OPPOSITE HOOK!! (If hook is not firmly engaged in hole, slippage and the possibility of rim scratching may occur) PROCEED TO STEP 3 (Photo #10) |
Photo #8
Photo #9
Photo #10 |
